12-15-2014, 08:26 PM
Today I picked up a brand new CasePro-100 from Mike at CasePro. I mounted a new Dillon 550B case feeder on it, plugged it in and started debulging .40 S&W. Without this machine I would debulge manually with a Lee Bulge Buster setup which is effective but very labor intensive. This unit runs at 30 cases per minute, which is not fast but slow and steady wins the race. The case feeder makes much more noise than the unit itself. I purchased .40 S&W and .38/.357 Mag dies so shortly I will have .40 S&W and .357 Mag ammo available in bulk. If you have clean cases, send me a PM on debulging. I will likely have this unit running in Trevor and can swap unbulged for bulged cases with you for a low cost. No more fear of a stuck (i.e. previously shot in a Glock I,II or III .40) case in your gun !